GAI-Tronics 393-001AD, RED ALERT Auto-dial Telephones - Manual (Page 25)

P UB . 42004-472B
A UTO -D IAL T ELEPHONE M ANUAL P AGE
23 of 33
f:\standard ioms - current release\42004 instr. manuals\42004-472b.doc
01/15
Ring-down Operation
Ring-down operation enables the telephone to go off-hook when the CALL push button is pressed. The
ring-down system must detect loop current and ring-down to the appropriate telephone.
Table 3. Auto-Dialing Key Sequence Setup
Feature Key
Sequence
Description
Default
CALL Button
Auto-dial
Number 1 DD ... *1 Assigns a telephone number to the auto-dial memory 1. DD ...
represents the telephone number, which can be up to 24 digits in
length.
For access to an outside line, a pause may be required in the
telephone number to wait for secondary dial tone. The *#
represents a pause in the telephone number.
Examples:
To assign the police emergency number 911 to the auto-dial
button, enter 911*1 .
To assign 911 when a “9” is required to gain access to a CO
line, enter 9*#911*1.
To store * or # as part of the auto-dial number, (such as for
speed dialing), enter these digits twice in succession.
*123456
789*0#
CALL Button
Auto-dial
Number 2
DD ... *2 Same as CALL Button Auto-dial Number 1 except the sequence
ends in *2 instead of *1. None
CALL Button
Auto-dial
Number 3
DD ... *3 Same as CALL Button Auto-dial Number 1 except the sequence
ends in *3 instead of *1. None
Primary Dial
Tone Delay # 1 0 N N The dial tone delay is the amount of time the unit waits for a
dial tone before auto-dialing the telephone number. (00 [20
seconds]; 01–15 seconds)
Example: To wait 5 seconds for a dial tone, enter # 1 0 0 5 .
03 (3
seconds)
Secondary Dial
Tone Delay # 1 1 N N This feature is only used if you must dial 9 to access an outside
line. It determines the amount of time (00–15 seconds) the
telephone waits for a second dial tone. The first programming
step indicated you must program 9*# and the number you want
the auto-dial to access. This programming parameter allows
you to choose the amount of time the telephone waits after
sending the 9 and pausing before dialing the auto-dial number.
Example: To wait 10 seconds for the second dial tone, enter
#
1 1 1 0 .
02 (2
seconds)
Ring-down
Operation *1
This option clears the telephone number to prevent auto-dialing
when the button is pressed. After the button is pressed, the ring-
down system must detect loop current and ring-down to the
appropriate telephone. None