GAI-Tronics VoIP Basic Programming Guide - Manual (Page 3)

Pub. 42004-481B
VoIP Telephone Basic Programming Guide Page 2 of 28
f:\standard ioms - current release\42004 instr. manuals\42004-481b.doc
10/13
Set-up & Configuration
Quick Start
The factory defaults will generally be sufficient in most cases, but the following steps must be taken as a
minimum:
 Provide an Ethernet connection and power (either 24–48 V dc or PoE).
 Using a web browser, browse to the default IP address (192.168.1.2).
 Enter a user name and password (Defaults:
user & password ).
 Set an IP address and net mask (or set DHCP) on the IP Settings page.
 From the General SIP Settings page (see Figure 2) select the SIP1 Info sub-page, and check that
ENDPOINT is ENABLED .
 On the SIP1 Info sub-page, give the telephone a LOCALID (usually its extension number).
 On the SIP1 Info sub-page, set DOMAIN, PROXY and REGISTRAR all to the address of the SIP
server. If registrar authentication is in use, also set a user name and password.
 Program any dial memories using the Dialing & Memories pages.
With these basic steps, the telephone will be able to make and receive calls in most cases. Check the
Current Status page to help diagnose problems. This will show whether or not the telephone is registered
and what is happening during calls.
N OTE : Make sure each unit is given at least a basic configuration before installing it. All units have
identical settings as factory defaults, so each one must be individually configured to give it a unique
identity on the network. This may be difficult to do after the units are installed.