GAI-Tronics 701-302ICS ICS AC-Powered Page/Party Plug-in Amplifiers - Manual (Page 6)

Pub. 42004-730L2B
ICS AC-Powered Page/Party
®
Plug-in Amplifiers Page: 4 of 20
f:\standard ioms - current release\42004 instr. manuals\42004-730l2b.doc
04/11
ICS AC-Powered Page/Party ® Plug-in Amplifiers
Models 751-001ICS, 701-302ICS & 701-304ICS
Figure 3. Model 751-001ICS
Speaker Amplifier
Figure 4. Model 701-302ICS
Handset/Speaker Amplifier
Figure 5. Model 701-304ICS
Handset/Speaker Amplifier with
Auxiliary Jack
Opening and Closing the Amplifier
The setting and adjustments vary with each model. Refer to the appropriate section of this manual for the
specific instructions for the applicable model. In some cases, the amplifier must be opened to gain access
to the PCBAs inside. Opening and closing the amplifier is as follows:
1. Place the amplifier on a flat surface and loosen, but do not remove, the two sets of rear cover screws
located on the top and bottom L-shaped slots. See Figure 6.
2. Slide the front panel with the screws sideways and then pull up to separate the front panel from the
rear section. The two sections are connected by a ribbon cable.
3. Lay the rear section to the left and the front section to the right with the PCBAs facing upward for
access to the applicable adjustments.
4. After the adjustments and settings have been made, slide the rear cover L-shaped slots over the top
and bottom screws ensuring no cables are being pinched. Tighten the screws.