Dynex DX-G1113 - Manual (Page 51)

Installing your car stereo 51
Chevrolet
S10 Pickup 1986-1993
S10 Blazer 1986-1994
GMC
S15 Pickup 1986-1993
S15 Jimmy 1986-1994
Oldsmobile
Bravada 1991-1994
To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the ashtray and the one screw inside the ashtray compartment.
3 Open the glove box, then remove the two exposed screws on the edge of the dash trim
bezel.
4 Cut and remove all mounting tabs on bracket L S-10 and the right bracket of bracket
set 5 except the top B tab on the right bracket. Each mounting tab has a letter
stamped on the back of the tab. Cut the tabs with the blade pointed away from you
and your fingers.
5 Go to “Completing the installation” on page 76.
B
DX-G1113.fm Page 51 Wednesday, August 16, 2006 3:38 PM