Dynex DX-G1113 - Manual (Page 56)

56 Installing your car stereo
Oldsmobile
Cutlass Calais 1984-1991
To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the console and glove box assembly, then remove the three screws below the
box.
3 Lift up the parking brake trim, then remove the two screws from the gear shift trim.
4 Remove the ashtray from the gear shift area, then remove the two exposed 7 mm
screws.
5 Using a screwdriver, depress the retainer tabs on the dash ashtray, pull the ashtray out,
then remove the two 7 mm hex-head screws from the ashtray bracket.
6 Remove the hardware that secures the factory mounting brackets to the factory head
unit. Remove and retain the brackets.
7 Go to “Completing the installation” on page 76.
2
S10 shown
as example
DX-G1113.fm Page 56 Wednesday, August 16, 2006 3:38 PM