Grandstream GVC3200 User Guide - Manual (Page 41)

Firmware Version 1.0.1.5 GVC3200 User Guide Page 40 of 97
APPLY PRESET
If you have already set preset on camera, you can apply preset via one of the following two ways:
• Access camera screen and press the digital keys on the remote control to adjust camera to the preset.
• Access preset screen and press the digital keys to switch to the corresponding preset, press the
yellow shortcut key to apply.
CAMERA PARAMETERS CONFIGURATIONS
Press the yellow shortcut key on the remote control to bring out camera parameter setting screen as
shown below. Refer to the table below and configure the parameters using navigation keys on the remote
control.
Figure 18 GVC3200 Camera Parameters Setting Screen