Greenheck Utility Distribution System - Manual (Page 7)

GREENHECK
¨ October 1999
7
PLUMBING CONNECTIONS
Installation
1. If system has field joint(s), plumbing must be
connected at the joint(s) before attaching
main service. Connect corresponding pipes by
aligning unions and tightening securely.
2. Connect all plumbing stub-ins to the main lines.
Provide all necessary nipples, couplers, unions,
etc. to make neat and proper connection.
3. Connect all hose assemblies to the appropriate
equipment as shown on drawing. Provide all
necessary ells and nipples to make neat and
proper appearance. (Please see hose installation
instructions on Page 8.)
4. Check all plumbing for leaks and tighten as
required.
5. Connect hood wash system (if provided) to spray
nozzles in hood.
6. Replace all access panels.
This equipment is to be installed with adequate
backflow protection to comply with federal, state
or local codes having jurisdiction.