Hypertherm Duramax Hyamp Robotic Torch - Manual (Page 22)

22 Duramax/Duramax Hyamp Robotic Torches Service Manual 807460
2 – Torch Setup
Install the torch
Depending on the type of torch, robot, and installation method, you may need to disassemble the FastConnect plug or
torch to install the torch. For the outside mounting method, it is not necessary to disassemble the torch. The torch can be
mounted per the instructions in
Mount the torch on page 30.
For the through-arm mounting method, see Figure 3 to determine if the robot’s through-arm cavity is large enough to
accept the torch lead’s FastConnect plug as assembled or with the 2 shells removed. If the through-arm cavity is large
enough for the FastConnect plug as assembled, route the torch lead through the through-arm cavity. Then, mount the
torch to the robot arm per the instructions in
Mount the torch on page 30.
Figure 3
1 2
3
4
5
6
4.20 cm
(1.65 inches)
3.68 cm
(1.45 inches)
1 Disconnect button
2 Tab
3 Top shell
4 Strain relief
5 Bottom shell
6 Mounting screws (4)