Hypertherm HT4001 - Manual (Page 17)

1-12 HT4001
12 SPECIFY THE MOTOR VALVE CONSOLE
This unit houses a plasma gas metering valve and a preflow/operate solenoid valve. Plasma
and preflow gas lines and an interface cable connect the motor valve console to the gas
console. The motor valve console also interfaces with the torch via a lead set consisting of a
plasma gas hose, a plasma off valve and one control cable. (See Figure 1-5)
Note: The motor valve console must be mounted within 10 feet (3 m) of the torch. In
most cases, this means that the valve console will be mounted to the torch lifter
station. Fabrication of mounting brackets may be necessary.
• Determine where the motor valve console will be mounted in relation to the torch and the gas
console, and order the console.
13 SPECIFY THE LEADS BETWEEN THE GAS CONSOLE AND THE
MOTOR VALVE CONSOLE
The lead package between the gas console and the motor valve console consists of one
plasma preflow gas hose, one plasma cut flow gas hose, and one control cable.
• Based on the distance (the path the leads will take) between the gas console and the motor
valve console, specify the appropriate leads.
14 SPECIFY THE WATER INJECTION HOSE BETWEEN THE GAS CONSOLE
AND THE REMOTE HIGH FREQUENCY CONSOLE
• Based on the distance (the path the leads will take) between the gas console and the remote
high frequency console, specify the appropriate hose length.
15 SPECIFY THE WATER INJECTION HOSE BETWEEN THE GAS CONSOLE
AND THE TORCH
• Based on the distance between the gas console and the torch, and allowing for the travel of
the torch, specify the appropriate part number.
16 SPECIFY THE CABLE BETWEEN THE GAS CONSOLE AND THE
HT4001 POWER SUPPLY
• Based on the distance (the path the leads will take) between the gas console and the