Hypertherm HT4001 User Manual
Page 21
1-16
HT4001
21
SPECIFY THE I/O CABLE BETWEEN THE HT4001 POWER
SUPPLY AND THE MACHINE COMPUTER
•
Determine the necessary length of the machine input/output (I/O) cable and order the
appropriate part number.
22
SPECIFY THE V/C CABLE BETWEEN THE HT4001 POWER
SUPPLY AND THE MACHINE COMPUTER
Order the voltage/current (V/C) machine computer cable if the cutting machine's computer
will be used to set voltage and current. This cable is needed if you order the programmable
remote. It is not needed when using the digital remote.
•
Determine the necessary length of the machine V/C cable and order the appropriate
part number.
23
SPECIFY THE WORK CABLE BETWEEN THE HT4001 POWER SUPPLY
AND THE WORK TABLE
The work (positive) cable connects the positive side of the HT4001 power supply circuit to the
workpiece via the cutting table. It should be kept as short as possible. If a slave power
supply is in the system, order two positive cables.
•
Determine the necessary length for the work cable and order the appropriate part number.