Glaze firing – Ivoclar Vivadent IPS InLine System User Manual
Page 44
44
Glaze firing
After the Stains and Characterization firing with IPS InLine System Shade/Stains, the Glaze firing is conducted.
– Remove IPS InLine System Glaze paste from the syringe and mix thoroughly. If a different consistency is desired, adjust
the consistency by diluting the material with IPS InLine System Glaze and Stains Liquid. Next, apply the Glaze material in
the usual manner using a brush. Make sure not to apply the Glaze material either in too thick or too thin layers.
– Minor shade adjustments may be carried out together with the Glaze firing.
firing parameters for the Glaze firing
T
°C/°F
B
°C/°F
S
min
t
°C/°F/min
H
min
V
1
°C/°F
V
2
°C/°F
850/1562
403/757
6
60/108
2
450/842
849/1560
When working with a furnace from another manufacturer, these parameters have to be adjusted accordingly! Finally, the
shade of the completed restoration is checked.
Shade adjustment with IPS InLine System Shade and Stains
These stains may be fired in a separate Stains firing. Minor shade adjustments and individual characterizations may also be
fired in the Glaze firing.
Dispense the desired quantity of IPS InLine System Shade and dilute and mix with IPS InLine System Glaze and Stains Liquid
to the desired consistency. Pooling should be avoided and the material must not be applied too thickly. If a more intensive
shade effect is desired, it is achieved by several staining procedures and repeated firing. The application of too many stains
results in an unnatural shade effect.
firing parameters for the IPS InLine System Shade/Stains firing (Stains and characterization firing)
T
°C/°F
B
°C/°F
S
min
t
°C/°F/min
H
min
V
1
°C/°F
V
2
°C /°F
850/1562
403/757
6
60/108
1
450/842
849/1560
Additional Stains and characterization firing cycles can be conducted with the same firing parameters.
If less gloss is desired, the holding time can be reduced to 1 minute.
If the gloss is unsatisfactory after the first Glaze firing, further Glaze firing procedures
may be conducted using the same firing parameters.