JB-Lighting Licon FX - Manual (Page 16)

12.02.2010 V1.0 -16-
In order to assign a key to a channel, press the corresponding key on the console. To
assign one of the display keys of this menu or the ESC key, press the softkey S-KEY
(repeat if necessary). Delete the assignment by pressing the softkey K-OFF . The
key selected for the assignment is shown on the display in the third line in the field
“KEY :“.
Note: The assignments made can be performed only outside this menu.
3.1.3 Remote control via external trigger input
Press the softkey EXTTR . The following submenu is shown:
The Licon FX comes with an external trigger input on the rear panel of the console to
which, for example, a footswitch with two switching functions can be connected. The
footswitch must simply connect the Go- or Go+ contact with the GND contact of the
connector.
It is possible to assign keystrokes on the console to these two switching functions.
This assignment allows remote control of certain console functions. The status of this
function is shown as REMOTE on the display and can be changed by pressing the
softkey REMOT . If you wish to change the assignment of the keys to the switching
functions of the footswitch, press the softkey SET. The following submenu is shown:
The display shows the assignment for one external switching function at a time. The
switching contact selected is shown on the display in the second line in the field
“EXTTRG “.
Select the other switching function of the footswitch with the encoder or by actuating
one of the two external switching contacts while the external trigger remote mode is
activated.
To assign a key to a switching function, press the corresponding key on the console.
To assign one of the display keys of this menu or the ESC key, press the softkey S-
KEY (repeat if necessary). Delete the assignment by pressing the softkey K-OFF .
In the factory default setting, the Go+ and Go- keys of the control section are
assigned to the external switching contacts. The key selected for the assignment is
shown on the display in the third line in the field “KEY :“.
Note: The assignments made can be performed only outside this menu.
3.1.4 Remote control via MIDI
This function is not available in the fader extension mode of the Licon FX to Licon 1,
since the MIDI interface is used here for data exchange with the Licon 1.
Press the softkey MIDI. The following submenu is shown: