JB-Lighting Licon FX - Manual (Page 30)

12.02.2010 V1.0 -30-
6.4.3 Changing flow control
-> The parameter flow control can be changed both in the STORE or EDIT mode and
by direct selection via the control section
Flow control determines the way in which you can switch from one step to another.
The current setting is displayed in the activated STORE or EDIT mode (see 6.1
Screen display in the STORE and EDIT mode
).
The current setting is also signalised by the two LEDs of the SOUND and the GO
key as well as by the right (green) LED of the TIME/MAN-FADE key of the control
section. These keys are used to change the flow control and are described in more
detail below.
6.4.3.1 Automatic sequencing with adjustable speed
This mode is displayed in the STORE or EDIT mode as follows:
Activate this mode paying attention to the three LEDs of the control section
mentioned above.
As illustrated, the three LEDs must not be activated for this mode. If activated,
deactivate the relevant LEDs by pressing the corresponding keys (repeatedly, if
necessary).
In the automatic flow mode, steps are switched forward automatically after a defined
period of time.
This time interval between the steps (also called chase frequency) is shown on the
display in the line for chase speed (see 6.1 Screen display in the STORE and EDIT
mode
) and can be changed with the encoder or the LEARN key of the control
section.
If you wish to change the chase frequency with the encoder while the STORE or
EDIT mode is activated, ensure that you are in the PARAM menu and that the menu
item FADET (fade time) is not displayed inverted. If activated, press the softkey
FADET for deactivation.
A change of the chase frequency with the LEARN key is reasonable, if you wish to
adjust the frequency to the beat of a running piece of music. Press the LEARN
key
twice to carry out this operation. The first keystroke will start the measurement of the
desired frequency (LED of this key begins flashing). The second keystroke will finish