JLCooper Eclipse Ethernet 2.6 for OSX - Manual (Page 23)

If you chose Setup Later during the installation process, there is an additional one time
step to perform. Open the application “Eclipse Ethernet 2.6”. It is located in
/
Applications/Eclipse Ethernet Software/. Choose Preferences… from the
Eclipse Ethernet 2.6 menu.
Set the IP address and port to match those that you entered on the Eclipse hardware
(see the Eclipse User Guide or the section of this manual entitled Hardware Setup).
This allows the Eclipse driver to communicate with the hardware.
The setting for Midnight or Silver Finish lets you choose the appearance of the
Eclipse 2.1 Ethernet application. Also, if you choose Midnight Finish the six Reset
buttons which are available on the Eclipse CX Midnight and Eclipse SX Midnight will
be displayed.
Eclipse Ethernet Software
20