Kemppi FastMig X 350 - Manual (Page 18)

FastMig X 350, X 450
16
EN
WISEROOT+
WFSpeed 1.5…8.0 m/min * Sets the wire feed speed.
Changes by steps of 0.05, when WFSpeed < 5 m/min,
and by 0.1, when WFSpeed > 5 m/min
WFS-Max Sets the limit for maximum WFSpeed
WFS-Min Sets the limit for minimum WFSpeed
FineTuning -9.0 … +9.0 Factory setting is 0.0
( = curve point) Adjusts the base current of the curve (heat of the arc)
within certain limits.
FineTuningMax -9.0 … +9.0 Step: 0.5 Sets the limit for maximum heat of the arc
FineTuningMin -9.0 … +9.0 Step: 0.5 Sets the limit for minimum heat of the arc
* Different welding programs may further restrict the value range.
WISETHIN+
WFSpeed 0.7…25 m/min * Sets the wire feed speed.
Changes by steps of 0.05, when WFSpeed < 5 m/min, and
by 0.1, when WFSpeed > 5 m/min
WFS-Max Sets the limit for maximum WFSpeed
WFS-Min Sets the limit for minimum WFSpeed
FineTuning -9.0 … +9.0 Factory setting is 0.0
( = curve point) Adjusts the arc voltage of the curve (arc length) within
certain limits
FineTuningMax -9.0 … +9.0 Step: 0.5 Sets the limit for maximum arc length
FineTuningMin -9.0 … +9.0 Step: 0.5 Sets the limit for minimum arc length
Dynamics -9…+9 Factory setting is 0 Controls the short circuit behaviour of the arc. The lower
the value the softer the arc is. The higher the value the
rougher the arc is.
MMA PROCESSES
Current 14…350/450 A Welding current
CurrentMax 14…350/450 A Set the limit for maximum current value
CurrentMin 14…350/450 A Set the limit for minimum current value
ArcForce -9…+9 Factory setting is 0 Controls the short circuit behaviour of the arc. The lower
the value the softer the arc is. The higher the value the
rougher the arc is.
StartPower -9…+9 Factory setting is 0 Adjusts arc ignition
CC PROCESS
Current 10…350/450 A Welding current
CurrentMax 10…350/450 A Set the limit for maximum current value
CurrentMin 10…350/450 A Set the limit for minimum current value
Dynamics -9…+9 Factory setting is 0 Controls the short circuit behaviour of the arc. The lower
the value the softer the arc is. The higher the value the
rougher the arc is.
StartPower -9…+9 Factory setting is 0 Adjusts arc ignition