Kreg KFT4X8 Face-Framing Table - Manual (Page 10)

R
Operating Instructions - Optional Screw Gun & Hose 9.
Optional Screw Gun
This table can accommodate an optional pneumatic screw
gun for use in assembling frames (Kreg part number
CT6030). An air regulator on the top of the transfer arm
regulates the amount of air that is supplied to the screw gun.
We recommend that you adjust the pressure to a level that
causes the screw gun to stall out when the screw has been
seated completely. To adjust, simply turn the regulator and
run the gun to reach the desired setting. We fi nd that a set-
ting around 60 psi works well for driving screws into oak with
the CT6030 screwgun.
Optional Polyurethane Coil Hose
This polyurethane coil hose (Kreg part number CT6023) is
a great complement to our Screw Gun. It is 8’ long, plenty of
length to reach across the table and has brass 1/4” NPT fi ttings
on both ends.
Regulator controls amount of air pressure to the screw gun.
Fitting where screw gun is connected to the table.
Screw Gun
Item# CT6030
Coil Hose
Item# CT6023