Kreg KFT4X8 Face-Framing Table - Manual (Page 5)

R
Step 1
Unpack all of the Framing Table components and remove them from
the pallet. Carefully lay the components out on the fl oor and make
sure you have everything needed to begin the assembly process.
Tools Required for Installation: Flat screwdriver, 1/2” socket and
wrench and a 1/4” hex wrench.
Step 5
With the help of others, lift the table into an upright position to
continue with the assembly process. See fi gure 3 above.
Step 2
Lay clamping table face down on a fl at surface. See fi gure 1.
Step 3
Remove the four hex bolts from the back of the table frame to
prepare it for attaching the legs.
Step 4
Place the legs in position so that the adjustable feet are point-
ing towards the bottom fence. Place hex bolts through frame
legs, tighten securely as shown in fi gure 2.
Follow the steps below for assembling your new Kreg Framing Table.
If you have any questions, please give us a call at 1.800.447.8638.
Step 6
Remove the black plastic end cap from the bottom frame rail
with a fl at screwdriver to reveal the socket head stop bolt &
nut. See fi gure 4 below.
Pry off black plastic end cap with a screwdriver.
Lay table surface fl at.
Tighten leg bolts securely.
Assembly Instructions 4.
Figure 1
Figure 2
Figure 3
Figure 4
Hex Bolts