Kreg KKS1020 Klamp Trak - Manual (Page 3)

• Add a ¾” surface to the top of your workbench.
Good if you would like to eventually replace the top of your workbench or return it to its original condition.
1. The Klamp Trak™ is exactly .695” thick, or slightly thinner than most ¾” plywood, MDF, or other composite sheets. Begin by cutting
your composite sheet to the same dimension as the top of your current workbench.
2. Place the trak on top of the sheet, where you would like it to be eventually positioned.
3. Trace around the trak using a pencil, and cut the appropriate material out using a saw of your choice.
4. Test the dimensions of your cut by placing the trak inside of the opening and checking to see that it rests flush with, or below the
surface of your workbench. Make adjustments as necessary.
5. Secure the sheet to the top of your workbench using any method you wish. (Screws, nails, recessed hex bolts, countersunk
flat-head bolts, etc.)
6. Re-test the dimensions and make adjustments as necessary.
Tip
TIP: If possible, attempt to secure the sheet to your workbench from the bottom side. This will eliminate the possibility of the screws
becoming loosened and interfering with your flat work surface.
Page 2 Klamp Trak TM Instructions