Kreg KKS1020 Klamp Trak - Manual (Page 7)

Tips
TIP: If you choose to use flat-head bolts, inserting up through the bottom of each hole, be sure to use the correct length of bolt. The must be long
enough to reach the t-slot, and short enough to not extend past the t-slot when the nuts are fully tightened. To find the correct length of bolt, simply
add the height of your table to the height of the t-slot, as shown at right.
For a less ‘fussy’ approach, use simple hex bolts inserted from the top of each hole, and tighten the nuts from the bottom side. This is easier and allows
for the use of a larger variety of bolt lengths, but also leaves hardware extending past the base of the table. Choose the method that suites your needs
the best.
Starting at one end, slide the trak over the nuts/
bolts while using your other hand to raise and lower
the bolts as necessary.
Once the trak is positioned how you like it, secure the
trak to the surface by tightening each bolt/nut.
Page 6 Klamp Trak TM Instructions