Marantz NA7004 - Manual (Page 14)

8
ENGLISH
n If the iPod stand becomes detached
Assemble as shown below.
"
"
$
$
Connecting a USB memory device
USB
memory
device
NOTE
• A computer can not be connected to and operate the unit via its
USB port.
• Do not use an extension cable when connecting a USB memory
device.
• For details about USB memory devices, see “USB memory”
(vpage 31).
n Setting your iPod on the iPod stand
1 Pass the iPod cable through
the opening on the iPod
stand.
2 Connect the iPod to the iPod cable.
3 Set your iPod on the iPod
stand.
NOTE
• Make sure to place the iPod stand on a fl at surface.
• Do not operate the iPod or iPhone while it is set on the iPod stand.
Doing so could cause the iPod or iPhone to fall off from the stand.
• Some iPod models cannot be set on the iPod stand because the
underside of the iPod is blocked when the iPod cable is connected.
• Make sure to disable the iPhone vibration function before you set it
on the iPod stand. If the iPhone vibrates when it is set on the stand,
it could fall off from the stand and be damaged.
• Do not use the iPod stand for purposes other than the one it is
intended to perform.
• Marantz will accept no responsibility whatsoever for any damage of
equipment connected to this unit while it is used.
iPod stand
1.NA7004N_ENG_0826.indd 8 1.NA7004N_ENG_0826.indd 8 2010/08/26 19:16:08 2010/08/26 19:16:08