Marantz NA7004 - Manual (Page 29)

23
ENGLISH
Getting Started
Connections
Basic Operations
Advanced Operations Advanced Operations
Troubleshooting
Explanation terms
Information
Specifi
cations
Index
The wireless receiver connection
By connecting a wireless receiver RX101 (sold separately) to this unit,
you can receive and playback audio signals from other devices using
the Bluetooth Communication Function.
• Use a Bluetooth device that is A2DP compatible.
• You can also use wireless receiver RX101 as an external IR receiver.
• For instructions on the wireless receiver settings, refer to the
RX101’s operating instructions.
M-XPort DIGITAL OUT D
COAXIAL OPTICAL COAXIAL
Wireless receiver
RX101
Remote control unit
Bluetooth device
(A2DP Compatibility)
When you connect RX101 to M-XPort on this unit, the function
switches to M-XPort.
Remote control jacks connection
When you use this unit connected to a Marantz amplifi er, this unit
receives operation signals sent from the amplifi er and operates
accordingly.
n Connection
Use the supplied remote connection cable to connect the REMOTE
CONTROL IN terminal of this unit to REMOTE CONTROL OUT
terminal of the amplifi er.
n Setting
To use this function, set the “IR Setting” to “Disable”. (vpage 23
“Remote control connection”)
• This setting will disable remote sensor reception of this unit.
• To operate the unit, point the remote control at the remote
sensor of the amplifi er.
To use this unit without connecting it to the amplifi er, set the IR
setting to “Enable”.
-XPort DIGITAL OUT DIGITAL IN
COAXIAL OPTICAL OPTICAL COAXIAL USB
FLASHER RS232C IN
OUT
IN
REMOTE CONTROL
NETWORK
Signal fl ow
Amplifi er
Remote connector cord (supplied)
Remote control connection
The unit can be controlled using the remote sensor of RX101 connected
to the unit and the Marantz amplifi er. Be sure to set “IR=Disable” when
controlling in this way.
NOTE
When making this remote control connection, be sure to set the IR
switch of RX101 and the Marantz amplifi er that are connected to the
unit, to ON.
Setting the remote control
1 Turn <INPUT> or press [MENU] .
Turns on the Menu settings mode and the Menu appears on the
display. (vpage 22 “Menu map”)
2 Use ui to select “Other”-“IR Setting”-“Disable”,
then press [ENTER/MEMO] , <ENTER> or p .
To restore original settings, repeat steps 1 and 2, select “Enable” and
press
<ENTER> .
NOTE
The unit cannot be controlled using the remote controller while
“Disable” is set.
1.NA7004N_ENG_0826.indd 23 1.NA7004N_ENG_0826.indd 23 2010/08/26 19:16:16 2010/08/26 19:16:16