Marantz NA7004 - Manual (Page 32)

26
ENGLISH
Setting the DAB [Tuner]
Making the DAB settings
1 Press [MENU] during DAB reception.
Turns on the Menu settings mode and the Menu appears on the
display. (vpage 22 “Menu map”)
2 Use ui to select “Tuner”-“item”, then press
[ENTER/MEMO] , <ENTER> or p .
[Selectable items]
Tuning Aid :
The reception sensitivity of the currently tuned in frequency is
displayed.
• The program can be received without noise when the cursor move
to the right of the sensitivity display.
Station Order :
The service list is created with the auto scan function.
Multiplex
Alphanumeric
(In order of frequency) (In alphabetical order)
DRC (Dynamic Range Control) :
Compress dynamic range (difference between loud and soft sounds)
1 1/2 Off
DAB Initialize :
When the “DAB Initialize” procedure is performed, all the preset
memory settings for the stations and DABs are reset.
Once initialization is completed, auto scanning is performed
automatically.
DAB Version :
The DAB module’s version is displayed.
Setting the others [Other]
Auto standby
With the Auto standby ON, this unit will automatically enter the
standby mode after about 30 continuous minutes of stop mode with
no operation.
• The default setting is “OFF”.
1 Press [MENU] .
Turns on the Menu settings mode and the Menu appears on the
display. (vpage 22 “Menu map”)
2 Use ui to select “Other”-“Auto Standby”, then
press [ENTER/MEMO] , <ENTER> or p .
3 Use ui to select “On”, then press [ENTER/MEMO] ,
<ENTER> or p .
The setting is entered.
NOTE
In the following situations, the Auto standby function does not operate.
• When an iPod or USB memory device is connected to the USB port
on the unit.
• When the input source is “TUNER”, “Digital In USB”, “Digital In
OPT” or “Digital In COAX”.
• When the input source is “M-XPort” and an RX101 wireless receiver
is connected to M-XPort.
• When the input source is “INTERNET RADIO”, “MUSIC SERVER” or
“ONLINE MUSIC”, and a ethernet cable is connected to NETWORK
connector.
Screen saver
Use the following procedure to set the screen saver.
1 Press [MENU] .
Turns on the Menu settings mode and the Menu appears on
the display. (vpage 22 “Menu map”)
2 Use ui to select “Other”-“Screen Saver”, then
press [ENTER/MEMO] , <ENTER> or p .
“Screen Saver” menu appears.
3 Use ui to select “ON” , then press [ENTER/
MEMO] , <ENTER> or p .
Button located on both the main unit and the remote control
BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control [BUTTON]
Symbols used to indicate buttons in this guide
8 、 9
[MENU]
[ENTER/MEMO]
u,i,o,p
[NUMBER]
(0-9)
<ENTER> u,i,o,p
[CLEAR]
8,9
[MODE]
1.NA7004N_ENG_0826.indd 26 1.NA7004N_ENG_0826.indd 26 2010/08/26 19:16:17 2010/08/26 19:16:17