Marantz SR4320N - Manual (Page 21)

15
ENGLISH
PRESET TUNING
With this unit you can preset up to 30 FM/AM stations in any order. For
each station, you can memorize the frequency and reception mode if
desired.
Auto Presetting
This function automatically scans the AM and FM band and enters all
stations with sufficient signal strength into the memory.
1 Select the FM band with the TUNER button.
2 Tune in the lowest receivable frequency.
3 Press and hold down the MEMORY button and TUNING/PRESET
button simutaneously, auto presetting will start.
4 Each time the tuner finds a station, the scanning will pause and
memory.
5 Operation stops automatically when all 30 preset memory positions
are filled or when auto scanning attains the highest end of all bands.
To stop the auto preset function at anytime, press the CLEAR
button.
Note:
If Auto Presetting is interrupted by pressing the CLEAR button, the
memory which has already been set is kept still.
Recalling a Preset Station
0
9 8 7
DIMMER
S-DIRECT MEMO CLEAR
SPKR A/B P.SCAN T.MODE F.DIRECT
PTY DISP./RDS
TREBLE BASS INPUT DIRECTION
PAUSE REC TUNE/SEARCH
CH SKIP CH SKIP 3
2,4
SPEAKERS
DISPLAY OFF
JOG MODE MUTE SLEEP SPEAKERS S-DIRECT
B
A
CLEAR F/P MODE TUNING/PRESET MEMORY
TUNER CD TAPE PHONO DVD VCR DSS CDR/MD
DOWN
3 2, 4
Manual Presetting
1 Refer to the “Manual tuning”, “Auto tuning” or “Frequency direct
call” section (P.14) above to tune in a desired station.
2 Press the MEMORY button on the front panel or press the MEMO
button on the remote control unit.
3 While “MEMORY” is still blinking (approx. 5 seconds ), select the
desired preset number by pressing TUNING/PRESET
or
button on the front panel or TUNE/SEARCH or button on
the remote control unit.
4 Then, press the MEMORY button or MEMO button again to store
the station in the preset memory.
When a number has been properly input, “MEMORY” indicator
stops blinking and goes out. The station is now stored in the
specified preset memory location.
Notes:
• To preset the station in the preset memory, press the ten key buttons
on the remote control unit.
• If a preset number already used is selected, the currently tuned
station is stored with the preset number and the formerly stored
station with the number is erased without any warning.
1 Press the F/P button on the front panel to change the display to
preset.
2 Select the desired preset station by pressing the TUNING/PRESET
or button on the front panel or press the CH SKIP or
button on the remote control unit.
Notes:
• To directly access the preset stations using the ten key buttons on
the remote control unit, select the desired preset station by entering
one or two digits using the ten key buttons.
• To return to the Manual Tuning mode, press the F/P button on the
front panel.
SPEAKERS
DISPLAY OFF
JOG MODE MUTE SLEEP SPEAKERS S-DIRECT
B
A
CLEAR F/P MODE TUNING/PRESET MEMORY
TUNER CD TAPE PHONO DVD VCR DSS CDR/MD
DOWN
1 2
SR4320N 01 ENG 03.11.28, 2:51 PM Page 15 Adobe PageMaker 6.5J/PPC