NavCom SF-2050 Rev.E - Manual (Page 52)

SF-2050 User Guide - Rev. E
D Event Input Configuration
Figure D1 details the wiring of the Event/Can cable
assembly NavCom part number P/N 94-310062-3003.
Refer to Chapter 2, Event for detailed electrical
specifications.
Table D1 details the wiring configuration required for
Event-Hi, and Event-Lo pulse sensing.
Figure D1: Event Cable Wiring Diagram
Pin #
Signal
Name
Event Sync Wiring
1 Event Lo Tie Event-Hi to Ground
2 Event Hi Tie Event-Lo to Ground
3 Ground N/A
Table D1: Event Wiring Connections
Once the cable is wired to correspond with the event
pulse requirements, the receiver must be configured to
output the message containing a time mark, referenced
to the time kept within the receiver, indicating when
the event is sensed.
D-50