Looping outputs, Looping output termination, 8/16 channel – OpenEye Gen6 X-Series User Manual
Page 26
32539AF
27
Looping Outputs
The 8/16 Channel X4 recorder has up to 16 looping outputs. Depending on the destination of the
looping outputs, each one may have to be terminated.
The 32 Channel recorder has up to 32 looping outputs. Connect the included 16 Channel BNC
Connector Cables to the 16 Channel Cable Adapter ports.
The video inputs/outputs are
75 Ώ BNC connectors. Make sure a video source is connected to the input
and then connect a cable to the Channel Out on the BNC Connector Cable.
Looping Output Termination
When it is necessary to terminate a looping output, the recorder has built in termination that allows you
to select individual outputs. It is not always necessary to terminate the output; it depends on the device
to which you are connecting. As a rule, if the image appears distorted or unviewable, it likely needs to
be terminated.
Always leave the dipswitch set to the ON position when the Looping Outputs are not used.
ON
Not connected to a monitor (Normal)
OFF
Connected to a monitor (Looped)