OWON AG-S series - Manual (Page 46)

7.SCPI
7. SCPI
The series support SCPI, and the users can operate and control the device by USB and COM interface.
For detailed information about SCPI please refer to
《 AG Series Waveform Generator SCPI
Protocol》.
8. Troubleshooting
1. The instrument is powered on but no Display.
 Check if the power is connected properly.
 Check if the Power Switch is in the proper voltage scale.
 Check if the fuse which is below the AC Power socket is used appropriately and
in good condition (the cover can be pried open with a straight screwdriver).
 Restart the instrument after the steps above.
 If the problem still exists, please contact Lilliput for our service.
2. The measured value of output signal amplitude disaccords to the displayed value:
Check if the actual load matches the set one. Please refer to "To Set the Output Load"
on P31.
3. The Sync output terminal does not output Sync Signal:
Check if the Sync Output switch is activated, and check if the current output signal has
a corresponding Sync Signal. Please refer to "To Set the Sync Output" on P32 for more
details.
If you encounter other problems, try to reset the settings (refer to "To Return to Default
Setting" on P34) or restart the instrument. If it still can not work properly, please contact
Lilliput for our service.
41