REMKO SuperTec-Monitor - Manual (Page 4)

Safety notes
Disposing of packaging
All products are packed for trans-
port in environmentally friendly
materials. You can make a valuable
contribution to reducing waste and
sustaining raw materials by only
disposing of packaging at ap-
proved collection points.
Disposing of the units and
their components
Only recyclable materials
are used in the manufac-
ture of the units and components.
Help protect the environment by
ensuring that the units or com-
ponents (for example batteries)
are not disposed of in household
waste, but only in accordance with
local regulations and in an environ-
mentally safe manner, e.g. using
authorised disposal and recycling
specialists or council collection
points.
Warranty
The precondition for possible
warranty claims is that the
ordering party or their representa-
tive
fully complete the warranty reg-
istration card and commissioning
report included with the unit, at
the time when the equipment is
purchased and commissioned,
and return it to
REMKO GmbH & Co. KG.
The warranty conditions are listed
in the "General terms and condi-
tions". Furthermore, only the par-
ties to a contract can strike special
agreements beyond these condi-
tions. For this reason, please
contact your contract partner
in the first instance.
Environmental
protection
and recycling
Carefully read the operating manu-
al before placing the unit in service
for the first time. It contains useful
tips and notes such as ha�-
ha�-
ard warnings to prevent injury and
material damage. Failure to follow
the directions in this manual can
result in endangerment to persons,
the environment and the equip-
ment itself and will void any claims
for liability.
■ Keep this manual and the re-
frigerant data sheet near to the
units.
■ The units and components
should be set up and installed
only by qualified personnel.
■ The set-up, connection, and
operation of the units and their
components must be in accord-
ance with the operating condi-
tions stipulated in this manual
and comply with all applicable
local regulations.
■ Mobile units must be set up
securely on suitable surfaces and
in an upright position. Station-
ary units must be permanently
installed before operation.
■ Modification of units and com-
ponents supplied by REMKO
is not permitted and can cause
malfunctions.
■ Units and components may
not be operated in areas where
there is an increased risk of
damage. Observe the minimum
clearances.
■ The electrical supply is to be
adapted to the requirements of
the units.
■
The operational safety of the
units and components is only as-
sured if they are fully assembled
and used as intended. Safety
devices may not be modified or
bypassed.
■
Do not operate units or compo-
nents with obvious defects or
signs of damage.
■
All housing parts and openings
in the unit, e.g. air intakes and
outlets, must be free of foreign
objects, fluids, or gases.
■
The units and components must
be kept an adequate distance
from flammable, explosive,
combustible, abrasive and dirty
areas or atmospheres.
■
Touching some parts of the unit
can result in burns or other inju-
ries.
■
Installation, repair and mainte-
nance work may be carried out
only by authorised specialists.
Visual inspections and cleaning
can be performed by the opera-
tor as long as power is discon-
nected from the equipment.
■
To preclude any danger from the
unit, take appropriate ha�ard-
prevention measures when
performing installation, repair or
maintenance work or cleaning
the units.
■
The units or components
are not to be exposed to any
mechanical stresses, extreme
levels of humidity or direct
sunlight.
REMKO SYSTEM MONITOR
FOR REMKO SUPERTEC INVERTER
4