Teac T-R680RS - Manual (Page 5)

5
TUNER IN
Amplifier
R L
A B
C
D
CAUTION:
< Switch off the power to all equipment before making
connections.
< Read the instructions of each component you intend to use
with this unit.
< Be sure to insert each plug securely. To prevent hum and
noise, avoid bundling the signal interconnection cables
together with the AC power cord or speaker cables.
LINE OUT jack
Analog 2-channel audio signal is output from this jack.
Connect this jack to the TUNER input jack of the amplifier
with an RCA cable.
Make sure to connect :
white plug q white jack (L: left channel)
red plug q red jack (R: right channel)
RS-232C connector
See page 14 for details.
Power cord (AC)
Be sure to connect the power cord to an AC outlet which
supplies the correct voltage.
Hold the power plug when plugging or unplugging the
power cord. Never pull or yank on the power cord.
C
B
A
Voltage Conversion
Be sure to remove the power cord from the AC outlet before
repositioning the voltage converter switch.
1. Locate the voltage selector on the rear panel.
2. Using a flat-bladed screwdriver, set to the appropriate
230V or 120V position according to your area.
IN NORTH AMERICA USE ONLY ON 120 V SUPPLY.
RESET switch
In the following cases, function buttons may not work
properly.
• When the system is damaged by electrical shock.
• When the power is irregular or has electrical noises.
In these cases, press the RESET switch once or twice with a
pencil or a ball-point pen lightly.
All the settings kept in memory (such as preset stations) will
be erased.
D
Connections