Teac T-R680RS - Manual (Page 8)

8
Radio Reception
Hold down the TUNING button for 0.5 to 2 seconds.
When a station is found, the tuning process will stop
automatically.
If you want to stop the tuning process, press the TUNING
button.
Selecting stations which cannot be tuned automatically
(manual selection)
Hold down (or repeatedly press) the TUNING button and
release it when the station you want to listen to is found.
When the TUNING button is pressed momentarily (0.5 second
or less), the frequency changes by a fixed step.
< “TUNED” is displayed when a broadcast is correctly tuned in.
Pressing this button alternates between Stereo mode and Mono
mode.
Stereo
FM stereo broadcasts are received in stereo.
The “STEREO” indicator lights on the display when an FM
stereo broadcast is tuned in.
< If the sound is distorted and the “STEREO” indicator light
flashes, the signal is not strong enough for good stereo
reception. In this case, change to MONO mode.
Mono
To compensate for weak FM stereo reception, select this
mode. Reception will now be forced monaural, reducing
unwanted noise.
Select AM or FM by pressing the corresponding button. 2
If the PRESET indicator is lit, press the TUNING MODE
button to select the manual tuning mode.
The PRESET indicator disappears from the display.
This button is used to change the tuning mode.
3
Select the station you want to listen to (auto selection). 4
FM MODE Button
Press the POWER switch (or ON button of the remote
control unit) to turn the unit on. 1
1 3 4
2