Thinklogical Q-4300 KMASS Modules Manual - Manual (Page 12)

Q-Series KMASS Modules Product Manual 12 Rev. B: August 2013
2. Connecting Q-Series KMASS Modules
All physical connections to the product use industry-standard connectors. Non-supplied cables
that may be needed are commercially available. All connections are found on the rear of the
chassis.
2.1 Fiber Optic Cables
All KMASS TX modules are connected to RX modules through fiber optic cables, either directly or
through a KVM Matrix Router to provide communication between the transmitter and the receiver.
The standard multi-mode fiber optic cables must be 50 or 62.5 microns, up to 1000 meters (3280’) long
and terminated with LC-type fiber optic connectors.
2.2. Transmitter Connections
A TX module connects to a source CPU and peripheral device sources through standard copper cables.
The connector configurations of the Q-Series Transmitters can be viewed in detail on pages 8-10.
2.3. Receiver Connections
An RX module connects to the destination USB and audio devices with their own standard cables. The
connector configurations of the Q-Series Receivers can be viewed in detail on pages 8-10.
Transmitter Connections Receiver Connections