Thinklogical Q-4300 KMASS Modules Manual - Manual (Page 16)

Q-Series KMASS Modules Product Manual 16 Rev. B: August 2013
3. Updating Q-Series KMASS Modules
Updates are available through Thinklogical ® . For technical assistance, please call us at:
1-203-647-8700.
3.1. Chassis Firmware Downloads
Thinklogical’s ® Q-4300 Chassis contains up-gradable firmware that controls its operation. Firmware
updates are sent to the Q-4300 Chassis by an application (KM_Download.exe) that can read which
Thinklogical
®
products are connected, then selects the appropriate file to send. The chassis firmware
controls the Alarms and the Front Panel.
Firmware files are stored in the following:
http://ftp.thinklogical.com/ftp/visualization/updates/Firmware.zip
The KM_Download.exe application is stored in:
http://ftp.thinklogical.com/ftp/visualization/updates/KmDownloadVxxx.zip
(where ‘Vxxx’ is the version number).
3.1.1. Firmware Update Preparation:
3.1.1.1 Retrieve Firmware.zip and the KmDownloadVxxx.zip application and place them in an
accessible directory in your CPU.
3.1.1.2. Install the KmDownload application by running setup.exe stored in
KmDownloadVxxx.zip.
3.1.1.3. Unzip the Firmware.zip file and place the contents in an accessible directory in your
CPU.
3.1.1.4. Ensure that the POWER ON/OFF switches located on the front of the Q-4300 chassis
are in the OFF position. Connect the supplied AC Power Cords to the two receptacles
located on the rear of the chassis and plug each one into a standard AC source. Turn
both POWER switches ON.
3.1.1.5. On the front panel of the chassis, the LCD will display the unit type and current revision.
Note the revision as shown.