Thinklogical SDI to HDMI Converter Manual - Manual (Page 10)

SDI to HDMI Converter, Rev. C 10 July, 2012
g: Adapt. Contrast Enhancer
Selects the menus for the Adaptive Contrast Enhancer (ACE) video processing
functions.
h: 3D Control Menu
Selects the menu for output 3D processing formats.
MAIN MENU:
D:
Audio Info and Setup
a:
Enable Audio Output
Enables the embedded audio output from the selected input.
b: Disable Audio Output
Mutes all embedded audio output channels.
c: Get Audio Info Input
Get Audio information from BNC Input.
d: Set Audio Delay
Audio Delay range is from -50 - +50 in mS with the default being 0.
e: Get Audio Delay
The programmed Audio Delay in mS.
f: Get Audio Channel Cfg.
Get the audio channel mapping.
g: Assign Audio Channels
Configure input to output channel configuration.
MAIN MENU:
E:
User Config Setups
a: Save Current Config
Saves the current system settings to the non-volatile Memory. Maximum of 20
characters for the record name.
b: Set Power On Config
This option will set the current configuration to the user in an accessible region of
flash. This configuration is restored during power up.
c: Restore Config Record
Recall any one of the current saved configuration records.
d: Restore Factory Config
By selecting this, the IEX3 will delete the stored power on configuration and will
re-configure to the factory default on the next power cycle (1080i @ 60 Hz).
Another way to achieve this is to hold down the front panel knob for a minimum
of 5 seconds during a power cycle.
e: Erase Record(s)
Erase a particular record or all records.