Thinklogical SDI to HDMI Converter Manual - Manual (Page 8)

SDI to HDMI Converter, Rev. C 8 July, 2012
3. Connecting the SDI to HDMI Converter
3.1 RS-232 Pin Out
3.2 User Menu Configurations:
The IEX3 has many configuration options and this document will cover these options in detail.
Every configuration can be set regardless of the user interface (e.g. RS-232, RS-422, Front
Panel Display, Web Interface). There are a lot of status and configuration settings that can be
viewed but are not output to the Front Panel display due to the display limitations. The RS-232
and RS-422 interface menus will have an 'exit' option. Selecting this option will display the menu
items one level up. The SPACE bar will repeat the current menu and the ENTER key will return
the user to the top level menu. This document will be formatted similarly to the configuration
menus that are displayed on power-up.
The RS-232 setup and configuration is as follows:
• Use Hyperterm or similar type interface.
• Baud rate is 115200, 8 bits, no parity, 1 stop bit, no flow control
• Emulate VT-100 mode
MAIN USER MENU:
A: Set Input Select
B: Set Output Select
C: Video Processing Setup
D: Audio Info and Setup
E: User Config Setups
F: System Settings
G: System Information