Thinklogical SDI to HDMI Converter Manual - Manual (Page 11)

SDI to HDMI Converter, Rev. C 11 July, 2012
MAIN MENU:
F:
System Settings
a: Ethernet Settings
Settings for the network interface.
Default Settings:
IP Address – 192.168.75.200
Mask – 255.255.255.0
Gateway – 0.0.0.0
b: Enable HDMI Output Video Mode
Enables the HDMI output to be in true HDMI mode.
c: Enable DVI Output Video Mode
Enable this option if the sink device is a true DVI monitor/projector.
d: Get Video Mode
This will return the current video mode.
MAIN MENU:
G:
System Information
The following is used for retrieving information regarding current setup and signal
detection information. The 'Get Genlock Info' is not available for display on the Front
Panel. The 'Get Input X', 'Get Output Info' will display the signal format only on the Front
Panel whereas the other communications interfaces will display more verbose info.
a: Get Software Version
Displays the System’s software version number.
b: Get FPGA Version
Displays FPGA 1 version number
c: Get Linux Version
Displays version of software currently running on ethernet interface.
d: Get Local Temperature
Displays the temperature inside the box
e: Get Input Info
Displays Information about the video and embedded audio signal on BNC Input 1
f: Get Output Info
Displays Information about the video and embedded audio signal on BNC
Outputs
MAIN MENU:
C:
Video Processing Setup
SUB-MENU:
a:
Comp. Artifact Reducer
This feature is used to reduce compression artifacts that are caused by video com-
pression schemes such as MPEG2. Mostly used on YCbCr 4:2:2 interlaced or pro-
gressive input video.
a: Comp. Arti. Reducer EN
Enables the Compression Artifact Reducer.