Verilink PRISM 41TDM (34-00275.4) Product Manual - Manual (Page 32)

24 C HAPTER 3: F RONT P ANEL I NTERFACE
Router IP Address Accepts the IP address of a default router, if one is present. This field allows
entering the address consisting of an octet separated by periods. Each value ranges
from 0 to 255 (Figure 3-8).
Subnet Mask Provided to manually override the subnet mask setting which is otherwise
discovered by the SNMP agent. This field allows entering the unit subnet mask
consisting of an octet separated by periods. Each value ranges from 0 to 255
(Figure 3-8).
Filter IP Address Accepts the IP address of the source packet filter. If any of these eight addresses
are set, access is allowed only by the specified IP addresses. This field allows
entering the filter IP address consisting of an octet separated by periods. Each
value ranges from 0 to 255 (Figure 3-8).
Trap IP Address Accepts the IP address of a network device where alarm reporting traps are to be
sent. The unit detects and reports alarms and provides several options for reporting
them including SNMP traps. When a network alarm occurs, the unit sends a trap
message to up to six destinations on the network. This field allows entering the
unit trap IP address consisting of an octet separated by periods. Each value ranges
from 0 to 255 (Figure 3-8).
SNMP Set Enables or disables the SNMP SET command. If this field is set to Disable, then
MIB variable changes are not allowed. Refer to Appendix A for detailed
information on the SNMP MIB variables.
Read Community This field accepts a character string of
up to 58 characters identifying the group
authorized to perform read operations as
displayed in Figure 3-9.
Write Community This field accepts a character string of up to 58 characters identifying the group
authorized to perform write operations.
System Contact This field accepts a character string of up to 58 characters identifying the person
responsible for a network device.
System Name This field accepts a character string of up to 58 characters identifying the
functionality of the network device.
System Location This field accepts a character string of up to 58 characters identifying the physical
location of network device.
Reset LAN Selecting Yes resets LAN interface of the unit.
Selecting the Reset LAN command disrupts data service.
Read Community
>public
Figure 3-9 System Edit