Verilink PRISM 41TDM (34-00275.4) Product Manual - Manual (Page 70)

62 A PPENDIX A: SNMP A GENT
ddsDteV54LoopDisabled(2) - The unit will not respond to V.54 loop codes
ddsDteRtsCtsDelay: (read-write)
Allows you to verify or select the delay used in the transition time on RTS and
CTS. For the PRISM 41TDM, only the ddsDteRtsCtsDelayNormal and
ddsDteRtsCtsDelayLong option are valid.
ddsDteRtsCtsDelayOff(1) - Delay is turned off
ddsDteRtsCtsDelayNormal(2) - Delay is a normal amount based on the data
rate and the hardware
ddsDteRtsCtsDelayLong(3) - Delay is generally doubled from the normal
delay
ddsDteRtsCTSDelayUserDefined(30) - Delay has been user defined to some
other value, when this value is set the delay is set to 30ms
ddsDteRtsStatus: (read-only)
Reports the current status of the RTS control lead
ddsDteRtsStatusHigh(1) - RTS control lead is in the active HIGH state
ddsDteRtsStatusLow(2) - RTS control lead is in the active LOW state
ddsDteCtsStatus: (read-only)
Reports the current status of the CTS control lead
ddsDteCtsStatusHigh(1) - CTS control lead is in the active HIGH state
ddsDteCtsStatusLow(2) - CTS control lead is in the active LOW state
ddsDteDcdStatus: (read-only)
Reports the current status of the DCD control lead
ddsDteDcdStatusHigh(1) - DCD control lead is in the active HIGH state
ddsDteDcdStatusLow(2) - DCD control lead is in the active LOW state
ddsDteDtrStatus: (read -only)
Reports the current status of the DTR control lead
ddsDteDtrStatusHigh(1) - DTR control lead is in the active HIGH state
ddsDteDtrStatusLow(2) - DTR control lead is in the active LOW state
ddsDteDsrStatus: (read- only)
Reports the current status of the DSR control lead
ddsDteDsrStatusHigh(1) - DSR control lead is in the active HIGH state
ddsDteDsrStatusLow(2) - DSR control lead is in the active LOW state
ddsDteDsrControl: (read-write)
Allows you to review and configure the DTE DSR lead (Circuit 107/CC)