Vuzix Wrap 1200AR User Guide - Manual (Page 18)

maxReality Viewer An application for viewing maxReality creations without
the need for Autodesk 3ds Max. It will install, even if 3ds
Max is not detected.
§ Open the decompressed software folder and run the “setup.exe” program.
During the installation process, the screens, options and buttons displayed will vary
from one version of the Windows to the next. We suggest choosing the default
options.
The maxReality installer will determine if Autodesk 3ds Max is installed on your
computer. If it is installed, both the maxReality plugin and maxReality Viewer
application will install. If neither 3ds Max program is found, only the maxReality
Viewer application will install.
maxReality will install as a trial version, usable for 15 days or 100 launches. If you
purchased a maxReality License, you will be presented with a license activation screen
when Autodesk 3ds Max load the maxReality plugin. Follow the activation
instructions to remove the trial version limitations.
Display Configuration
Your Windows display system must be configured correctly to work with the Wrap
eyewear. You need to set:
• A display resolution and refresh rate supported by both your desktop or
laptop monitor
• Mirrored or duplicate displays – desktop and eyewear display the same
image
Tip: If you are using an older version of Windows the “Duplicate these displays” option may be
referred to as Mirror or Clone modes.
The Wrap 1200AR supports display resolutions of 640x480, 800x600, 1024x768,
and 1280x720, each at a 60 Hz refresh rate.