Welltech IP-380 v.1.0 - Manual (Page 90)

iP380 User Manual
Welltech Technology Co., Ltd.
90 / 104 2012/11/01
2.5.4.2. Instruction
Item Explanation
Update Active Default: CPU+DSP xxxx.ssh; Upgrade file format.
Load From File The location of the updating file.
Upgrade [Button] Execute updating firmware.
Note：It takes about 2~3 minutes when iP380 is updating firmware. Please do not turn off power
adapter during updating firmware and you can not make any call either.
2.5.4.3. Operate Instruction
Step 1: In [Firmware Upgrade] web page, please press [select] to choose the location of the
updating file, (see Figure 1).
(Figure 1)
Step 2: Enter the page of [select file], select the updating file (Example: voip.ssh), press [open]
button and will go back to [Update Firmware], then press [Update] button, (See Figure 2).
(Figure 2)
Step 3: There will show a [Note], it tells you some messages that you should not do them during
the updating firmware. When you are sure of these notes very clear, please press [OK]
button to close the [Note]. Then iP380 will start to update firmware, (see Figure 3).
(Figure 3)
Step 4: There will show a page of [Note Information], it tells you the system is updating and it will
reboot automatically as updating completely (See Figure 4).
(Figure 4)