Westermo IDW-90 AT - Manual (Page 18)

18 6620-3200
<min_tx_rate> Numeric values which specify the lowest (<min_tx_rate>) and
and highest (<max_tx_rate>) rate at which the modem may establish a
<max_tx_rate> transmit connection. Non-zero values for this subparameter are
decimal encoded, in units of bit/s. The possible values for each
modulation are listed in Table 1.
Actual values will be limited to possible values corresponding to
the entered <carrier> and fall-back <carrier> as determined during
operation. (default = lowest (<min_tx_rate>) and highest (<max_
tx_rate>) rate supported by the selected carrier.)
Reporting Current or Selected Values
Command: !+MS?
Response: +MS: <carrier>, <automode>, <min_tx_rate>, <max_tx_rate>, <min_
rx_rate>, <max_rx_rate>
Note:- The current active settings are reported under control of the !+MR
parameter.
Example: !+MS=V90, 1, 300, This example uses default values, allowing
33 600, 300, 33 600 maximum system flexibility to determine
optimal receive and transmit rates during
operation.
Reporting Supported Range of Parameter Values
Command: !+MS=?
Response: +MS: (<carrier> range), (<automode> range), (<min_tx_rate> range),
(<max_tx_rate> range), (<min_rx_rate> range), (<max_rx_rate>
range)
Example: +MS: (B103, B212, V21, V22, V22B, V23C, V32, V32B, V34), (0,1),
(300-33 600), (300-33 600)