Westermo IDW-90 AT - Manual (Page 62)

62 6620-3200
*wiol – General IO list
This command is used to program the list of IO entries with parameters and data.
The list can contain up to 10 entries
Syntax:
Set up a service entry:
*WIOL=<entry>, <service>, <flag>, <timeout>, <priority>, <data1>,
<data2>, <data3>, <data4>, <data5>, <data6>
Request the format string:
*WIOL=?
*WIOL : (1-10), (0-7),(0-3), (0-255), (0-1), (0-20 char),
(0-160 char), (0-20 char), (0-2), (0-8 char), (0-20 char)
List all table entries. Listing will pause every 3rd entry and wait
for any key hit to continue. ESC will terminate.
*WIOL?
List entry 3.
*WIOL=3?
<entry> IO entry number, up to 10 entries can be defined.
<service> IO entry service
0=NONE No service defined for this entry
1=DIAL Makes a connection to the number defined in <data1>.
2=SMS <data1> Destination number of the SMS
<data2> SMS-message
<data3> SMS service provider number
<data4> SMS protocol type (0=NONE, 1=UCP, 2=TAP)
<data5> Password if required by provider.
3=TEXT Make a connection to number defined in <data1> and transfer text defined in
<data2>.
4=EMAIL Reserved for future use, service not implemented.
5=OUT Make a connection to the number defined in <data1> and set/pulse the remote
output according to pattern defined in string defined in <data2>.
The connection is terminated after the pattern is transferred.
6=CMD AT command specified by <data1> is executed when the entry is triggered.
7=TRANS Makes a connection to number defined by <data1>, IO is transferred transparently
between the two units. The transparent mode must be ended by a timeout.