Westermo IDW-90 AT - Manual (Page 72)

72 6620-3200
?? – help
Displays help texts for all commands
Notes:
(Note 1)
After issuing one of these parameters, execute the “save” com-
mand to store the configuration in non volatile memory. To acti-
vate and use the new setting you have to run the “reset” com-
mand.
(Note 2) Command syntax for setting hlc, llc and bc
An empty parameter has to be entered by "-".
Example:
Deleting of LLC-value: LLC -<cr>
Entering a new LLC: LLC 8890<cr>
(Note 3) Different modes for V.110 baudrate adaption
- Outgoing call:
brn # 0: ISDN message SETUP will be created with or without LLC(brn)
depending on the setting of dial.v110llc;
The B channel (V.110 baudrate) will use the baudrate set by brn
(independent of br or recognized local baudrate)
brn = 0: "adaptive": same mechanism as brn # 0; the V.110 baud rate will
be created by br rsp. the recognized local baud rate.
- Incoming call:
brn # 0 : no LLC received: accept incoming call, use in B channel brn for
V.110 baudrate.
LLC received compliant to brn: accept incoming call
LLC received not equal to brn: Reject incoming call:
DISCONNECT (cause = incompatible destination).
brn = 0 : "adaptive":
no LLC received: accept incoming call, use in B channel br rsp. the
recognized local baud rate for V.110 baud rate.
LLC received: accept incoming call, use in B channel the baud rate
derived from the LLC as V.110 baud rate.
The usage of the LLC is controlled by the IDW-90+Configurator
command dial.v110llc.