Preparing the di/do connector, Hardware manual – ACTi I91 User Manual
Page 13
Hardware Manual
Preparing the DI/DO Connector
Depending on your surveillance needs, you may connect digital input or output devices to your
camera to trigger events or notifications.
Digital Input (DI) devices can be used to notify the camera about an activity in the camera site.
DI can be triggers of events. For example, yo
u can connect a “panic button” to the camera; as
such when the panic button is pressed, the alarm signal will be sent through the camera. Other
common DI device applications are emergency button, smoke detector, passive infrared
sensor, etc.
Digital Output (DO) devices are external devices that are activated by the camera upon an
event inside the camera. For example, you can connect an “alarm horn” to the camera; as
such when an event occurs inside the camera (e.g. detected intruder), the alarm horn will
sound. Other common DO device applications are motion-triggered lights, electric fence,
magnetic door locks, etc.
You can connect up to two DI and two DO devices to your camera.
To connect input devices (DI), map the pins to one of the pin combinations below:
Device
Mapping Instructions
Digital Input 1 (DI1)
GND
Connect the wires of the first input device to
GND
and
DI1
.
DI1
Digital Input 2 (DI2)
GND
Connect the wires of the second input device to
GND
and
DI2
.
DI2
To connect output devices (DO), map the pins to one of the pin combinations below:
Device
Pin
Mapping Instructions
Digital Output 1 (DO1)
12V
Connect the wires of the first output device to
12V
and
DO1
.
DO1
Digital Output 2 (DO2)
12V
Connect the wires of the second output device to
12V
and
DO2
.
DO2