Other connections, Connecting a power adaptor (optional) – ACTi KCM-7911 User Manual
Page 21
Hardware Manual
Other Connections
This section describes the procedures in preparing the external devices that you can connect
to the camera. The camera supports DC12V power input, Digital Input and Output (DI/DO) and
Audio Input and Output devices using the bundled terminal blocks. The use of these devices,
however, is optional.
Connecting a Power Adaptor (Optional)
The camera consumes 9.6W power when powered by a Power over Ethernet (PoE) switch
that is IEEE802.3af compliant. In case of using a non-PoE switch or your PoE switch has
limited power supply, you can purchase a power adaptor and directly connect the camera to a
power outlet. The power adaptor must be connected to the supplied terminal block before use.
To do this, follow the procedures below:
1.
Loosen the screws of the
12V
and
GND
pins of the power terminal block.
2.
Take note that a standard power adaptor cable has two (2) different wires:
White stripe: Connects to 12V Pin
Connects to GND Pin