ACTi KCM-7911 - Manual (Page 8)

www.acti.com
Hardware Manual
8
3) Reset Button
The Reset button is used to restore the factory default settings of the camera, including the
administrator’s password.
The reset button can be used for following purposes:
1. The administrator ’s password has been forgotten and therefore the camera cannot be
accessed.
2. In case of IP address, mask, or allow/deny filter related issues, resulting with inability to
modify these settings.
3. In case of connectivity issues or abnormal video quality.
How to do the reset properly?
Step 1: Disconnect the power supply (e.g. disconnect the power adaptor or a PoE switch /
injector).
Step 2: Press and hold the reset button.
Step 3: Connect the power supply while keeping the reset button pressed. During this time the
Power LED may turn on and turn off several times.
Step 4: Wait for 45 seconds and then release the reset button.
4) Power Button
Press the Power button to reboot the camera.
5) Audio Input / Output
This connector connects to audio input and output devices, such as microphones and
speakers, using the bundled terminal block. See Connecting Audio In / Out Devices
(Optional) on page 26 for more information.
6) Digital Input / Output
This connector connects to digital input or output devices, such as alarm triggers, panic
buttons, etc. Digital Input (DI) and Digital Output (DO) devices are used in applications like
motion detection, event triggering, alarm notifications, etc. See Connecting DI/DO Devices
(Optional) on page 23 for more information.
7) Micro SDHC Card Slot
Insert a Micro SDHC card here for local recording (card not included in the package).