Allmand Brothers MAXI LITE II - Manual (Page 31)

3-6 USING THE LIGHT TOWER
ADJUSTING THE LIGHTS
The light bar and light fixtures must be adjusted to the
work angle you want prior to raising the tower.
ROTATING THE LIGHTS TO THE DESIRED
ANGLE
To adjust the light bar at the work site:
1 Release the light bar park pin by pulling the ring out
and turning it 90° so that the pin remains in the
retracted position.
2 With the park pin released, the light bar can be
manually rotated. It has enough built-in resistance
that the bar will stay in position after the operator
has directed the lights on the work zone.
If the light bar rotates too easily or does not stay in
position, remove the cap plug from the center of the
light bar cover and tighten the nut to achieve the
proper resistance, then replace the cap plug.
WARNING
BURN HAZARD
The light fixtures become extremely hot during use.
Always use caution and wear heat-resistant gloves
when handling the lights or allow the lights to cool
down before handling.
Park pin
Light
tower
Light
fixture
Light
bracket -
Grasp here
to adjust
Adjustment
lock lever