Allmand Brothers MAXI LITE II - Manual (Page 39)

4-2 MOVING THE LIGHT TOWER
PREPARING THE LIGHT TOWER FOR
DELIVERY
The MAXI LITE II light tower requires service as well as
proper operation in order to provide the performance
and safety it has been designed for. Never deliver or put
the machine into service with known defects or missing
instructions or decals. Always instruct the customer in
proper operation and safety procedures as described in
this Operator’s Manual. Always provide the manual with
the equipment to ensure proper and safe operation.
CHECKLIST
• Visually inspect the equipment to ensure that all
instructions and decals are in place and are legible.
• Inspect the light tower locking bar latch assembly,
which locks the light tower in the vertical position,
for proper operation.
• Check the hitch assembly and safety chains to make
sure that they are in good condition.
• Check the outriggers and jacks to make sure that
they operate properly.
• Inspect the light assemblies for damage and test for
proper operation.
• Inspect the electrical wiring for signs of damage or
excessive wear.
• Check the ground rod cable and the grounding lug.
Make sure that they are clean, undamaged, and
functional.
• Inspect the tires to ensure that they are in good
condition and are properly inflated.
• Check the engine oil, fuel, engine coolant levels, and
hydraulic fluid levels, if so equipped.
• Check to make sure that this Operator’s Manual, the
Engine Operator’s Manual, and the Generator
Operator’s Manual are with the equipment.
• Install the plug into the Fluid Containment System.
• Inspect the machine physically for damage, and
repair if necessary.
After completing the pre-operation checklist, operate
the tower through a complete operation cycle,
following the operating instructions in the
MAXI LITE II Operator’s Manual.
ALWAYS READ AND UNDERSTAND THE
INSTRUCTIONS FIRST
Before trailering, transporting, or lifting your light
tower, read the chapter on
SAFETY on page 2-1.
DANGER
ELECTROCUTION HAZARD
Do not operate the light tower if the insulation on the
electrical cord or other electrical wiring is cut or worn,
or if bare wires are exposed. Repair or replace
damaged wiring before starting the engine.
WARNING
UNSAFE OPERATION HAZARD
Never permit anyone to install or operate the
equipment without proper training.
NOTICE
See the appropriate section in the Engine Operator’s
Manual and the Generator Operator’s Manual for
additional pre-operation checks.