Allmand Brothers MAXI LITE II - Manual (Page 51)

5-6 MAINTAINING THE LIGHT TOWER TRAILER
MAINTAINING THE ELECTRICAL
SYSTEM
Refer to the Generator Operator’s Manual for all general
scheduled maintenance procedures.
BALLAST PANEL
The ballast panel is located on the left, front side of the
light tower trailer. The ballast panel can be accessed by
removing the left side panel, then removing the
internal access cover. The ballast panel contains the
four tower light lamp ballasts and capacitors.
The safety messages that follow have WARNING level
electrocution hazards.
WARNING
ELECTROCUTION HAZARD
Only qualified electricians should service or perform
replacement procedures. Ballasts and capacitors are
capable of discharging high voltage. Always use
appropriate personal safety clothing and gear when
servicing electrical equipment.
WARNING
ELECTROCUTION HAZARD
High voltage is present when the engine is running.
Never attempt to service electrical components while
the engine is running.
WARNING
ELECTROCUTION HAZARD
Do not operate the light tower if the insulation on the
electrical wiring is cut or worn, or if bare wires are
exposed. Repair or replace damaged wiring before
starting the engine.
Capacitors
Lamp ballasts
Ballast cover
Ballast
panel