Allmand Brothers MAXI LITE II - Manual (Page 41)

4-4 MOVING THE LIGHT TOWER
PREPARING FOR TRAILERING - STOWING
THE LIGHTS
The light bar and fixtures must be stowed before
trailering or transporting.
To stow the tower lights for trailering:
1 Make sure that all lights are off and tower is lowered
to the full down position.
2 Release the light bar park pin by pulling the ring and
turning it 90 degrees so that the pin remains in the
retracted position.
3 Rotate the light bar into the trailering / transport park
position (in line with trailer) and engage the park pin
by twisting the park pin ring until the plunger is
released and the pin engages and locks into the hole
in the light bar.
4 Reposition the light fixtures for trailering / transport
by pulling them down into the lowest position and
face the fixtures toward the center of the trailer.
WARNING
BURN HAZARD
The light fixtures become extremely hot during use.
Always use caution and heat-resistant gloves when
handling the lights or allow the lights to sufficiently
cool down before handling.
Light bar
Light fixture
Light tower
Tongue
jack
Rear
outrigger
jack
Lunette ring
Side
outrigger
jack
Safety chains
Tongue jack crank
Ball hitch coupler