Allmand Brothers MAXI LITE II - Manual (Page 44)

MAXI-LITE II
4-7
3 Connect the light connector from the vehicle harness
to the trailer harness.
Make sure that there is adequate slack in the wiring
harness to prevent binding or disconnection when
turning.
4 Before trailering, check all lights for proper operation.
LIFTING THE LIGHT TOWER
The fully loaded light tower and trailer weighs
approximately 3,500 lbs. (1,588 kg) with four fixtures.
The Maxi-Lite II light tower is equipped with bottom
forklift pockets and a lifting eye for lifting or hoisting.
Forklift blades must be at least 60” in length to lift the
trailer.
WARNING
CONTROL HAZARD
Attach the safety chains properly and securely
between the towing vehicle and trailer before
trailering. Never let the chains drag on the ground
when trailering.
NOTICE
Do not allow excessive harness slack or the wiring
harness can be damaged from scraping the ground.
Four- or seven-pin
trailer light harness
connector
Trailer safety
chains
WARNING
ROLLOVER HAZARD
Before lifting, lower the light tower and shut down
the tower lights and the engine. Refer to “
PREPARING
FOR TRAILERING - SHUTDOWN ” on page 4-3 .
WARNING
CRUSH HAZARDS
Always make sure that the lifting device you are using
is in good condition and is rated for the maximum
capacity of the task to safely lift the light tower trailer.
Always get assistance when using a forklift, crane, or
hoist when loading or unloading.
Only use the lifting eye on the lifting bar to lift or hoist
the unit with a hoist or crane.
Only use shackles or a locking-type hook when lifting.
Do not stand or walk under the unit when lifted. Keep
others away from the unit when lifted.
Only lift one light tower at a time.