Eneo PXB-2280Z10 D - Manual (Page 31)

31
Operating Instructions
NETWORK AF ZOOM CAMERA
: Detects and compensates the defective pixels.
• LEVEL: Defines the level of detection and low value detects more pixels.
Be sure to set the value so that the pixels are uniformly blinking over the entire
screen. Too low value will get the bad results because too many pixels are
detected as the bad pixels and the maximum number of pixels for compensation
will be filled by the upper area.
: Sets the composite video signal NTSC(30/60fps) or PAL(25/50fps).
6-5. COMM*: Defines the camera ID, BAUD RATE and PROTOCOL.
6. SPECIAL FUNC
6-1. DEFECT DET
6-3. SYSTEM
: Select image bit range. Setting FULL is 100%, COMP is 75% compressed,
or USER is controlling level from 0 to 32.
6-2. IMAGE RANGE
6-4. HD FORMAT
SPECIAL FUNC
DEFECT
IMAGE RANGE
SYSTEM
HD FORMAT
COMM
COMP
NTSC/PAL
1080P/30fps
[ BACK ] [ SAVE ] [ DFLT ]
Procedure ]
1) Close the lens and make the screen dark.
2) Sets the defect LEVEL from 0 to 10.
3) If there are some defective pixels, press the ‘MENU’ key then the detection
starts up.
: Sets digital output resolution. 1080p/30(25)fps is fixed.
(*) It is not supported
• ID: Assigns the camera ID from 1~255 for the comm. address.
• BAUD RATE : 2400bps is fixed.
• PROTOCOL : PELCO-D is supproted